With the clips on the foam core but the paper backings still on the cable clips, slide the divider into your drawer, ensuring it’s centered and completely vertical. NOTE: I started with two cable clips on each side of the divider, but really, one clip on each side was sufficient for stability! Do NOT remove the paper backings on the cable clips. To do so, place one or two cable clips on each side of the foam divider (as shown in the two photos below). Next, you will “dry fit” this cut into your drawer. Use a ruler and X-Acto knife to make as precise of cuts as possible. Taking 1/2″ off the width dimension allows room for the cable holders. WIDTH of drawer – 1/2″ X HEIGHT of drawer. To create your first divider, you will cut a rectangle from your foam core or cardboard in the following dimensions: I had just enough leftover wallpaper from the feature wall to outfit 6 drawers. Next, if desired, line the bottom and/or sides of your drawer with contact paper, shelf liner, peel-and-stick wallpaper, etc. Start by measuring the height, width and depth of the drawer you want to outfit with dividers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |